A message on Hayward cartridge
systems:
I have found a common mistake that is easy to make when reassembling
Hayward Swimclear cartridge filter systems.
The “Top Closure Plate” that sits on the four inserted cartridges does specify up and down positions but is easy to miss.
Note: If this “Top Closure Plate” is inserted upside down, dirt will
flow in and then out of the filter system.
How to identify top from bottom:
The
top has four cylinder shaped ends with straight top edges. There is also a
break in each. These longer tops (longer than the bottom) are meant to push
against the filter lid holding the filter cartridges down and in place even
under pressure.
The bottom has four smaller
(smaller than the top side) cylinder shaped ends with curved in top edges. It
is these curved edges that help the closure plate to be inserted to each filter
top. (The pictures below show the plate upside down)
Because these ends were meant to fit in tight (to create
a seal not allowing water to pass between the plate and the cartridges) you may
need something to hammer each side in place.
If the closure plate is not
correct, the filter will not filter the pool water.
Wonderfully claimed. The following pointers are actually incredible. I be thankful pertaining to revealing these people. Hawyard Bag Fitler
ReplyDeleteHayward filter cartridge is installed in my swimming pool, now the time has come to change it, thanks for sharing such an important information, it will be really very helpful.
ReplyDeleteThanks for taking the time to discuss this, I feel strongly about it and love learning more on this topic. If possible, as you gain expertise, would you mind updating your blog with extra information? It is extremely helpful for me. read more
ReplyDeleteIt is a fantastic post – immense clear and easy to understand. I am also holding out for the sharks too that made me laugh. at iav.org.au
ReplyDelete