The pool cleaner replacing skirts

The pool cleaner the replacing skirts:

Replacing front skirt:

The front skirt is made up of two parts available in two kits. written by www.WCPandS.com. For the standard white pool cleaner, the “Brackets for skirt” part number is 896584000-419 for the top half and “Skirts with rollers” part number is 896584000-259 for the bottom.

Start by connecting each of the two halves together before attaching to the pool cleaner. This will be done four times.

The bottom section of the top half (see picture below) will be pushed into the top section of the bottom half 

This is a tight fit and requires a strong hand to snap the two together.

Each combined piece will now be inserted one at a time as shown.

For the first two, one side is pushed under an open slot and slid in place.

Push the first all the way to one end

 

For the third, it will need to be inserted on the opposite side of the two already placed in.

One side of the fourth and final piece will be inserted as the other 3 were, but now the opposite side will need to be forcibly snapped in.

Push the last side down and snap it in place.

Replacing the back skirt:

The back skirt is made up of two parts. For the white pool cleaner “Skirt Kit B” the part number is 896584000-105 and for “Brackets for Skirt” thepart number is 896584000-419. Note that two of the “Brackets for skirt” are extra and will not be used.

The two largest pieces will be at both ends of the skirt line.

Only 2 of the 4 “Brackets for skirt” will be used.

Start by attaching one skirt bracket with one bottom skirt.

These are snapped together by hand. Do this twice for the two middle skirt pieces.

Now you have the 4 sections that together make up the entire back skirt.

Slide one section of the single long pieces into the back skirt line.

Now slide the other side down and in all the way to one side.

Take one of the middle two part pieces and insert one side. Then, slide that piece all the way over to the already inserted piece.

With the other single long piece, insert one side (like in picture) and then slide over and in.

For final middle section piece, insert just one side by sliding it in.

The remaining side needs to be pushed down and snapped in by hand.

Once inserted, each piece should move back and forth freely.

See the pictures to make sure that your skirt parts have the same angle as the parts in the pictures.

With the two extra parts.